Pistol designed for the application of polyurethane foams. High quality-thanks to the use of suitable, quality materials of stainless steel, aluminum and brass. The elements most vulnerable to wear due to foams and corrosion, have been additionally protected by PTFE coating.

Purpose:

The installation foam gun is designed to apply single-component foam available in pressurized containers.

The gun makes it easier to perform such work as:

• sealing ,
• installation of windows and doors,
• filling insulation gaps, sealing and insulating partitions
.
• insulation of walls and roofs

1. Start work

Vigorously shake the foam container, for about 15 seconds. Screw in the adjustment screw, located on the back of the gun, as far as it will go, so as to completely block the movement of the trigger lever. Remove the lid from the foam container, and then screw the container into the gun nut until a perceptible resistance. Then unscrew the adjustment screw, located on the back of the gun by turning it until resistance is felt. Press the trigger lever and fill the gun with foam.

The gun is ready for use. A stream of foam comes out when the trigger lever is pressed. Releasing the pressure of the trigger lever stops the flow of foam. The volume of the mounting foam stream is adjusted by turning the adjustment screw.

2. Activities after completion of work

Turn the adjustment screw as far as it will go to block the movement of the trigger lever. It is recommended not to unscrew the foam container from the gun. Care should be taken to ensure that there is always a screwed-on, at least partially filled container to the gun, this helps keep the foam inside the gun under pressure. This prevents the foam from drying inside the gun. If the break in the use of the gun is more than a month, the gun should be cleaned with a mounting foam cleaner.

Do not allow the foam to dry inside the gun. The dried foam can only be removed mechanically. If dried foam is left inside the gun, it will lead to irreversible obstruction of the gun.

3

3. Reuse of the gun

Vigorously shake the gun with the container attached, for about 15 seconds. Cut off the tip of the hardened foam with a sharp knife. Turn the adjustment screw counterclockwise and release enough foam so that the stream becomes uniform. After these steps, the gun is ready for use.

4. Replacing the container

If the foam has stopped coming out of the container, replace it with a new one. To see if the container is completely unobstructed, point the nozzle toward the waste container and press the trigger lever until the gun nozzle is completely unobstructed. Install immediately, without cleaning the gun, a new container and follow the steps.

5. Cleaning the gun

Screw the container from the gun. Put the spray tip on the cleaning agent container and clean the residual fresh foam on the gun. Remove the spray tip and screw the cleaning agent container into the gun. Proceed in the same way as with the foam container

Fill the gun with the cleaning agent and let it sit for about 10 minutes. Press the trigger lever again and clean the inside of the gun with fresh cleaner. Unscrew the cleaning agent container. Using a cloth, remove the cleaning agent residue from the junction between the container and the gun and cover with a thin layer of petroleum jelly.

Do not clean the gun with corrosive agents.

When using the gun continuously, the gun should be cleaned, as described above, every 2 - 3 months.

 

Usage warnings:

Warning! Always use personal safety equipment at work.