82502
BOOSTER CABLES
- Przewody rozruchowe 200 A o długości 2 m.
Emergency power cables 200 A - 2 m
Cables 200 A made of copper wire, which guarantees high conductivity and flexibility even at the lowest cross sections. The wire insulation made of non-flammable plastic retains high flexibility at low temperatures and perfectly dissipates heat.
Technical data:
- length: 2
- nominal load [A]: 200
Usage warnings:
Jumper cables are used to emergency start the engine using the battery of another vehicle. Correct, reliable and safe operation depends on proper use, therefore: before working with the cables, read the entire manual and keep it. The supplier is not liable for any damage resulting from failure to comply with the safety regulations and recommendations of this manual. When starting, avoid contact between car bodies. Do not overload the cables. Select the nominal load of the cables based on the information attached to the battery, including the maximum battery charging current. Before starting work, check the condition of the cables for damage and whether the cable insulation is cracked, cut or damaged in any other way. It is forbidden to use damaged cables. Damaged cables must be replaced with new ones. Connect the cables so that the conductive parts do not come into contact with elements other than the battery terminals. Do not strain the cables. This will reduce the risk of the cable becoming disconnected during starting. Do not expose cables to hot surfaces, sharp objects and edges. Cables may become hot during startup, be careful. Check the vehicle documentation to see if it contains any contraindications to the use of jumper cables. Stop both vehicles and ensure that the vehicle does not start automatically when the engine is started. Make sure both vehicles have batteries with the same voltage rating.Ask a question
Write your opinion
