Hydrodynamic paint aggregate 480W flow rate 2.1l/min

Hydrodynamic paint aggregate for working with latex paints, acrylic paints when painting walls and ceilings, as well as enamels for metal and stains for wood.

Wide paint stream and high flow allow painting large areas in much less time than with a traditional roller, electric guns and smaller models of aggregates.

Painting with an aggregate, thanks to the strong blast of paint particles, removes dust from the walls and does not cause chipping/peeling of paint flakes that stick to the paint roller when working with a traditional roller.

The aggregate does not require power from an external source of compressed air, the coating material is pumped from the aggregate to the gun using a flexible hose. The aggregate has been equipped with a pump that sucks the paint from any tank by itself.

Long reinforced pressure hose - as much as 15 mb - gives you the opportunity to set up the aggregate, for example, at the scaffolding without having to bring buckets of paint and the machine to a higher height.

The included 300 mm extension allows you to paint ceilings in rooms up to 3.5m high without having to climb a ladder.

Possibility to buy a set of extensions with a length of 100 and 180 cm.

Generator mode switch

Can be set in two positions. The vertical position of the switch lever allows you to drain the paint inside the unit. The switch should always be set in this position during breaks in operation. The horizontal setting of the switch lever allows spraying with the gun.

Pressure adjustment knob

Rotating the knob will increase the amount of material sprayed. Turning the knob clockwise increases the pressure, while turning it counterclockwise decreases the pressure of the paint being sprayed.

Gun trigger lock

Allows you to lock the trigger from being accidentally depressed. If the lock knob is set perpendicular to the trigger then the trigger is locked and it is not possible to depress it.

Switch

Under the switch there is a fuse button. If the device overheats (e.g., due to nozzle clogging, paint flow stopping or due to paint being too viscous) the fuse will cut off power to the product and the button will slide out of the housing.

Parameters:

• application: oil paints, acrylic paints, emulsion paints, primers, impregnants
• nozzle size: 517
• power: 480W
• power output: 2 l/min
• hose length: 15 m
• protection rating: IP20
• max. operating pressure: 22.7 MPa